Модуль для калибровки прошивок блоков управления Bosch ME(D)17.8.10, используемых в мототехнике CFMoto. Доступны для редактирования следующие калибровки: Air Control: Accelerator pedal mapBoost limiters: Boost limitation by coolant temperature, Boost limitation from engine speed, Boost limiter to prevent overspeed Exhaust gas model: Exhaust gas temperature, Exhaust gas temperature 2 Idle speed: Desired idle speed, Desired idle speed MT, Desired idle speed with A/C, Desired idle speed with A/C in drive Injector control: Injection end timing 1, Injection end timing 2, Injector dead time, Injector flow constant Knock control: ignition advance angle, Knock retardation step for spark advance, Knock sensor sensitivity factor cyl 1, Knock sensor sensitivity factor cyl 2, Knock sensor sensitivity factor cyl 3, Knock sensor sensitivity factor cyl 4, Minimal ignition angle, Retardation recovery Limiters: Engine speed limitation 1, Engine speed limitation 2, Engine speed limitation 3, Engine speed limitation by oil temperature, Vehicle speed limiter (if found, not guarantee) Spark advance: Optimal spark advance Switch operating modes: Requested torque threshold to detect full load Target lambda: Delta correction for lambda adaptation, Target lambda at part load, Target lambda at warm up in closed loop, Target lambda for component protection, Target lambda in acceleration request Throttle: Air mass flow through throttle valve, Desired throttle angle Torque limitation: Allowed torque from accelerator pedal cold engine in monitoring, Allowed torque from accelerator pedal in monitoring, Offset tolerance for allowed torque 1, Offset tolerance for allowed torque 2, Engine speed dependent torque 1, Engine speed dependent torque 2, Maximal allowed torque 1, Maximal allowed torque 2 Torque model: Driver requested torque base sport 1, Driver requested torque base sport 2, Driver requested torque base sport 3, Driver requested torque base sport 4, Driver requested torque base sport 5, Driver requested torque reverse, Optimal indicated torque, Relative drive desire torque from driving pedal - ECO, Target air filling calculated form indicated torque, Ignition angle efficiency, Lambda efficiency, Minimal defined efficiency DTC mask |
Для работы модуля требуется наличие ключа защиты
Новые поступления
Модуль EMS3150 Renault ChiptuningPro 7
Дополнительный модуль для чип-тюнинга автомобилей Renault, ЭБУ EMS3150 Модуль позволяет производить ..
15000 ₽
Модуль EMS3110 Renault ChiptuningPro 7
Дополнительный модуль для чип-тюнинга автомобилей Renault, ЭБУ EMS3110 Модуль позволяет производить ..
15000 ₽
Модуль EMS3155 Renault ChiptuningPro 7
Дополнительный модуль для чип-тюнинга автомобилей Renault, ЭБУ EMS3155 Модуль позволяет производить ..
15000 ₽
Модуль Bosch EDC7UC31 MAZ / KRAZ / URAL ChiptuningPro 7
Дополнительные модули для чип-тюнинга автомобилей КАМАЗ и ГАЗ, ЭБУ Bosch EDC7UC31.Модуль B..
25000 ₽